Differences in Processing For Polyether And Polyesleter TPU

Apr 12, 2025 Leave a message

Comparative Differences in Processing for polyether and polyesleter TPU

1. Drying

As we know, polyurethane is a polar polymer that gradually absorbs moisture when exposed to air. When TPU pellets that have absorbed moisture are processed by melting, the water vaporizes at processing temperatures, leading to uneven surfaces and internal bubbles in the finished product, which reduces the material's properties. To ensure product quality and prevent bubble formation due to moisture vaporization during processing, TPU pellets generally need to be dried before processing.

As analyzed earlier in the comparison of hydrolysis stability between polyester and polyether TPU, polyester is more susceptible to chain scission by water molecules, and the acid generated from hydrolysis can further catalyze the breakdown of polyester. Under the same conditions, polyester TPU typically has a higher moisture content than polyether TPU. Therefore, during the drying process, special attention must be paid to thoroughly drying polyester TPU and strictly controlling the drying conditions.

2. Pressure Holding Stage

During injection molding, whether in the pre - plasticizing stage or the injection stage, the polymer melt is subjected to the combined action of internal static pressure and external dynamic pressure. In the pressure - holding stage, the polymer melt is subjected to high - pressure action. Under this pressure, the free volume between molecular chain segments is compressed. As the free volume between molecular chains decreases and the large molecular chain segments come closer together, the inter - molecular forces are enhanced, which is manifested as an increase in viscosity. Additionally, polyether - type TPU has lower ether - bond cohesive energy and a smaller bond - rotation barrier, which results in weaker inter - segment interactions within the molecular chains. Therefore, during compression, the relative displacement of the molecular chains is greater, and the viscosity can vary over a larger range. Moreover, because the molecular chains of polyether - type TPU are much more flexible than those of polyester - type TPU, permanent deformation is less likely to occur. Consequently, when pressure - holding is applied during the processing of polyether - type TPU, compared with polyester - type TPU, a longer pressure - holding time is required for polyether - type TPU.

3. Processing Time

Generally speaking, an increase in molecular weight lengthens the molecular chain segments, slows down the movement of the molecular chain's center of mass, and increases the chances of relative displacement cancellation between chain segments. This enhances the flexibility of the long molecular chains, increases entanglement points, and makes chain disentanglement and slippage more difficult. As a result, the flow process encounters greater resistance, requiring more time and energy, which is manifested as a sensitivity of viscosity to shear. Typically, polyester - type TPU has a broader molecular weight distribution than polyether - type TPU, hence it requires a higher processing temperature. Polyether - type TPU has nitrogen - oxygen bonds that are more easily broken, thus allowing processing at relatively lower temperatures.

4. Processing Temperature

Typically, polyester - type TPU has a broader molecular weight distribution than polyether - type TPU, hence it requires a higher processing temperature. Polyether - type TPU has nitrogen - oxygen bonds that are more easily broken, thus allowing processing at relatively lower temperatures.

5. Pressure

Polyester - type TPU has a higher molecular cohesive energy, and the nitrogen - oxygen bonds in its molecular structure are also more difficult to break. Therefore, processing polyester - type TPU, which involves breaking its molecular bonds, requires higher temperatures and pressures.

6. Cooling

Polyester - type TPU has greater internal friction and higher molecular cohesive energy, making it more difficult to cool down and return to its normal state. Therefore, a longer cooling time is required.

7. Flowability

Polyether - type TPU has lower ether - bond cohesive energy and a smaller bond - rotation barrier. As the relative molecular weight of polyether increases, the chains become more flexible. The molecular chains of polyether - type TPU have a high degree of flexibility, thus exhibiting good flowability, which is slightly inferior in polyester - type TPU.