Related Effects Of Various Indicators Of Polyether Polyols On Foam Products-Acid, Molecular Weight And Potassium Ion

Feb 04, 2026 Leave a message

Related Effects Of Various Indicators Of Polyether Polyols On Foam Products-Acid, Molecular weight and Potassium ion

 

AV can be expressed in the form of hydroxyl value, so high acid value consumes more TDI, but the amount is negligible due to the small amount.The high reaction temperature and the increase in catalyst concentration will increase the side reactions and increase the acid value; the high acid value consumes more amine catalysts during foam formation, which reduces the reactivity. In severe cases, the foam product will shrink and close the pores due to the consumption of too many amine catalysts.

 

The properties of most polymers increase with the increase of molecular weight, such as tensile strength, elongation, melting point, hardness and glass transition temperature, etc. Increase with the increase of molecular weight, while solubility is the opposite.This relationship does not change significantly after the molecular weight is increased to a certain value.The molecular weight of polyether can be calculated from the hydroxyl value and function.For the same grade, the size of the molecular weight is affected by the unsaturated bond, so the influencing factors that cause the molecular weight change are similar to the influencing factors of the degree of unsaturation. The two are a complementary relationship, that is, the same grade of polyether, the degree of unsaturation increases → the molecular weight decreases; the degree of unsaturation decreases → the molecular weight increases.

 

The presence of residual catalysts in the polyether will directly affect the preparation of the polymerization system and the physical properties of polyurethane products, because potassium ions promote the formation of rigid and cross-linked urea formates and diuretics during the chemical reaction of polyurethane, which hardens the foam products, reduces elasticity, and gels in severe cases.At the same time, the potassium ion content is high. When foaming with TDI as a raw material, the foaming heat cannot be dissipated in time, causing heartburn in the foam.