TDI-polyester-based product with a very low free TDI content (typically less than 0.1%).
This results in a non-toxic polyurethane system and reduces processing hazards. It offers lower viscosity, longer pot life, and faster demolding. Its compatibility with a range of curatives enables high productivity. The resulting elastomer exhibits good abrasion resistance, compression set, tear strength, and dynamic properties.
Unreacted free TDI <0.1%.
The viscosity increases slowly after mixing.
Low viscosity.
Excellent dynamic performance.
Long operating time.
High carrying capacity.
The release time is short.
Improve high temperature performance.
| Low free TDI series | ||||||
| Model | T5025 | T5030 | T5040 | T5045 | T5050 | T5055 |
| Polyol | Polyester | |||||
| Operation Conditions | ||||||
| NCO, % | 2.4±0.2 | 3.3±0.2 | 4.0±0.2 | 4.4±0.2 | 5.0±0.2 | 5.5±0.2 |
| Viscosity (90ºC)/mPa·s | 2700 | 1600 | 1500 | 1450 | 1130 | 750 |
| Process temperature /ºC | 90 | 90 | 90 | 90 | 85 | 80 |
| MOCA Pot Life, Mins | 14 | 12 | 10 | 8 | 8 | 8 |
| Demold Temperature/time, ℃/mins | 100/60 | 100/60 | 100/60 | 100/30 | 100/60 | 100/30 |
| Post cure, ℃/h | 100/15 | 100/15 | 100/15 | 100/15 | 100/15 | 100/15 |
| Properties | ||||||
| Hardness(Shore A) | 73±2 | 83±2 | 85±2 | 90±2 | 93±2 | 95±2 |
| Tensile strength /MPa | 41 | 52 | 51.7 | 52.4 | 56 | 55 |
| Elongation at Break /% | 750 | 550 | 540 | 480 | 460 | 440 |
| 100% Modulus/MPa | 2.8 | 4.3 | 6.3 | 8.2 | 11.1 | 14.7 |
| 300% Modulus /MPa | 4.1 | 13 | 13.8 | 16.3 | 21.3 | 29.6 |
| Tear strength /(KN/m) | 48 | 85 | 107 | 112 | 117 | 135 |
| Rebound / % | 40 | 45 | 38 | 37 | 36 | 34 |
| Compression set B(70℃,22 hours) | 37 | 34 | 29 | 33 | 33 | 32 |
