What's the polyurethane insulation foams for solar water heaters?
As a thermal insulation material, polyurethane rigid foam has an irreplaceable position in many aspects due to its extremely low thermal conductivity and convenient molding process.
However, as a reaction-molded polymer, its molding shrinkage (the foam volume after completing the molding reaction is smaller than the maximum volume during the molding process) inevitably becomes one of its main flaws. The existence of molding shrinkage often causes the final volume of the foam to be smaller than the volume of the filled cavity, causing peeling of the foam and the shell, seriously affecting the appearance, insulation effect and even service life of the product.
Therefore, in most applications, polyurethane insulation layers often use increased filling foam density and molding to solve this problem.
Solar water heaters are inconvenient to mold due to their special structure (thin shell and liner, complex nozzle shape), and high-density filling will inevitably increase costs. Currently, relatively high-density free foam filling is used , the defects this brings to the solar water heater include: the foam layer is separated from the shell, the shell is squeezed during foam molding, and the inner tank is deformed. The above defects are particularly serious when they occur at the mouth of the heat collecting tube, resulting in a large number of defective products.
Shandong BEIQIAO realized that reducing the shrinkage rate during foam molding without increasing the foam filling density is the key to the materials used in solar water heaters, so it provides a combination of polyethers with higher performance to reduce the peeling of the foam body from the shell. , the probability of deformation of the liner shell is greatly reduced.
Polyether composite materials for solar water heaters are composed of polyether, foaming agent, catalyst, foaming agent and other components. According to different foaming agents, they can be divided into high fluorine type, fluorine-free 141b type, fluorine-free all-water type, etc. Several types.
Usually the polyether composition is a light yellow or brown-red viscous transparent liquid with no coagulation, thick matter or unevenness, and no mechanical impurities.
