What Are The Main Properties Of Polyurethane Elastomer 1?

Apr 07, 2024 Leave a message

What are the main properties of polyurethane elastomer?

 

1.1 Hardness

The hardness range of ordinary rubber is from Shao A20 to Shao A90, and the hardness range of plastic is about Shao A95 to Shao D100, while the hardness range of polyurethane elastomer is as low as Shao A10 and as high as Shao D80, and does not require the help of fillers. What is particularly valuable is that elastomers still have good rubber elasticity and elongation under plastic hardness, while ordinary rubber can only obtain higher hardness by adding a large amount of fillers at the expense of significantly reducing elasticity and elongation. It is reported that when the hardness is higher than 75D, its elasticity will be seriously lost, and when the hardness is higher than 85D, it will no longer be an elastic material.

 

1.2 Mechanical strength

Polyurethane elastomer has high mechanical strength, which is reflected in Young's modulus, tear strength and load-bearing capacity.

1.2.1 Young's modulus and tensile strength Within the elastic limit, the ratio of tensile stress to deformation is called Young's modulus (E) or elastic modulus.

Polyurethane elastomers, like other elastomers, only obey Hooke's theorem at low elongation (about 2.5%). But its Young's modulus is much higher than other elastomers. Moreover, the Young's modulus range of polyurethane elastomers covers rubber and plastics, and the range is unmatched by other materials.

1.2.2 Tear strength

The tear strength of polyurethane elastomer is very high, especially the polyester type, which is about twice that of natural rubber.

1.2.3 Carrying capacity

Although the compressive strength of polyurethane elastomer is not high at low hardness, polyurethane elastomer can increase the hardness while maintaining rubber elasticity, thereby achieving a high load-bearing capacity. The hardness of other rubbers is greatly limited, so the load-bearing capacity cannot be greatly improved.

 

1.3 Wear resistance

The wear resistance of polyurethane elastomer is very outstanding. The test results are generally in the range of 0.03~0.20mm3/m, which is about 3~5 times that of natural rubber. In actual use, due to the influence of factors such as lubricants, the effect is often better. Abrasion resistance is closely related to the tear strength and surface condition of the material. The tear strength of polyurethane elastomer is much higher than that of other rubbers, but its friction coefficient is not low, generally above 0.5. This requires adding oil lubricants, or adding a small amount of molybdenum disulfide or Graphite, silicone oil, tetrafluoroethylene powder, etc. to reduce the friction coefficient and reduce frictional heat generation. In addition, the friction coefficient is also related to factors such as material hardness and surface temperature. In all cases, the friction coefficient increases with decreasing hardness and increases with increasing surface temperature. It reaches its maximum value around 60°C.