Advantages of polyurethane spraying:
It has good thermal insulation performance and low thermal conductivity, which is better than polystyrene board. It is currently the best thermal insulation material;
It has good waterproof performance, with a sealing rate of 95%, and rainwater will not seep through the holes;
Polyurethane spraying has dimensional stability, high production efficiency, fast molding speed and high efficiency;
Spray coating construction can directly implement spray foaming processing on substrates of various shapes;
The service life is up to 30 years, and the performance will not change greatly;
Can be prefabricated, can be foamed on site, can be poured, can be sprayed, and the construction method can be changed as needed
Floor thermal insulation and sound insulation polyurethane products have low thermal conductivity and strong bonding strength, which can protect the main structure of the building, increase the service life of the building, and effectively reduce the erosion of moisture on the building. With the addition of modified graphite flame retardant, it can reach B1 level resistance. The improved formula of the material can improve the indoor sound insulation effect without reducing the thermal insulation performance too much. The construction process has little environmental pollution, and has the characteristics of simple and convenient operation, short maturation period, and fast construction.
Disadvantages of polyurethane spraying:
The foaming rate will decrease below 10 degrees, and the product is limited by external conditions during use.
The spray molding speed is fast, and it is not easy to spray it very smoothly. It is normal to have uneven surfaces;
Long-term direct contact with black and white materials during polyurethane spraying may cause dizziness, headache, nausea and vomiting, and severe cases may collapse suddenly.
3. Polyurethane spraying process and common problems
The performance indicators of polyurethane spraying should comply with the requirements of JC/T998-2006 "Spraying Polyurethane Rigid Foam Insulation Materials". During on-site spraying operations, the ambient temperature should not be lower than 10°C, the wind force should not be greater than 5m/s (level 3 wind), the relative humidity should be less than 80%, and no construction is allowed on rainy days.
If the foam is abnormal during spraying, the blast hole is large, the foam is black due to excess black material, and the foam is white and soft due to excessive white material. You can refer to the reasons:
If the mixing is not good, there will be an interlayer in the middle of the foam and local shrinkage;
Out of proportion, finishing and shrinking;
The temperature is not suitable, the foaming is too small or the fire is too high
